Velux KLR 100 Manuel d'utilisateur télécharger pdf (Page 34)

66 VELUX VELUX 67

A B





ENGLISH ENGLISH

When the skylight is closed, press with a pointed

object through the operator cover hole marked A for

at least 5 seconds. The skylight operator and other

electrical products connected to the skylight will run

brieﬂy back and forth indicating that they are ready to

be registered.

To reinstate the connection between skylight and

remote control, register the skylight with its electrical

products in the remote control again. Please refer to

the instructions in section Initial set-up or Registering

new products.

Note: The same procedure applies to a change of

opening from in-reach to out-of-reach applications.

The skylight can be adjusted to two dierent open-

ings, depending on the installation height. By default

the opening is about 12" (300 mm), but for in-reach

applications where the skylight is installed less than

8 ft. (2.5 m) from the ﬂoor, the shorter 4" (100 mm)

opening must be used.

To change the opening, reset the skylight as described

in items 1 and 2 in section Resetting and preparing for

registration.

Disconnect the main power supply for more than

60 seconds. Reconnect the power, insert a pointed

object in the skylight operator cover hole marked B

and press for at least 10 seconds or until the skylight

opens. Button B must be pressed within 30 seconds

of reconnecting power. The skylight will open to the

opening that was already set in the skylight operator.

When the skylight stops, press brieﬂy with a pointed

object through operator cover hole marked B to

change this opening to the alternative length. When

the skylight has stopped at the desired opening, press

brieﬂy with a pointed object through operator cover

hole marked A to accept the new opening setting. The

skylight closes.

Adjusting the opening

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 110 111

Pas de commentaire

Velux KLR 100 Manuel d'utilisateur Page 34